Free The Tone Red Jasper RJ-2V Overdrive Efektipedaali
- Helsingin myymälä Varastossa
- Tukku Varastossa
The RJ-1V Red Jasper won popularity as Free The Tone’s first low gain drive pedal but was discontinued in 2018 because some of its component parts became difficult to obtain. Now, after three years the Red Jasper has come back. Again, the Red Jasper RJ-2V features a sound resembling that of vintage tube amps, namely, smooth highs, punchy mids, full but tight lows, and natural and pleasing compression feel. We carefully examined and selected every component to refine the sound of this product.
In general, the sonic output of an overdrive unit in the lower registers varies with its gain setting and the type of guitar or amp/cabinet used. There can be many occasions where you wish to correct an excess or deficiency of the lower register components. The RJ-2V newly adds a mode switch to select from four modes of different low frequency characteristics (cut-off frequencies). With this you can adjust the lower register output to suit the characteristics of your guitar/amplifier.
In addition, the Red Jasper has a Hi-Cut tone circuit to adjust higher registers. Free The Tone adopted a passive circuit with minimum phase error in the guitar signal to attain high-fidelity amplification, to get natural tone, and to keep guitar’s original timbre. This circuit provides a natural change like the tone control on a guitar and turning the knob counterclockwise cuts highs gently. From a subtle whispering tone to a powerful and persistent drive sound, it can output your guitar sound expressively.
Free The Tone’s original HTS (Holistic Tonal Solution) circuit is implemented. Unlike conventional buffer circuits, the HTS circuit attains both sound and low noise by performing impedance conversion while fully bringing out sound characteristics of the guitar. The HTS circuit prevents degradation of guitar timbre even when the effect is turned off.
Mode selector switch setting
The low end of the bass range is gradually cut from setting A to setting D.
Setting A SW1: ON / SW2: ON
Setting B SW1: ON / SW2: OFF
Setting C SW1: OFF / SW2: ON (Factory default setting)
Setting D SW1: OFF / SW2: OFF
Features
Carefully chosen high reliability components
Passive type tone circuit.
Mode switch to select low end frequency characteristics from four settings
Controls: Level, Hi-Cut, Drive
Switch: Free The Tone's original HTS circuit
LED: Effect On / Off
Inputs: 1x 6,3 mm Jack
Outputs: 1x 6,3 mm Jack
Power: 9-volt battery, AC adapter
Dimensions: (WxDxH): 100 x 123 x 53 mm (including footswitches, jacks, etc.)
Weight: 320 g (excluding battery)
Astoundingly excellent signal-to-noise ratio
Merkki | Free The Tone |
---|